Parts brokers, not a warehouse. We locate NOS, used, antique and custom parts you cannot buy off a shelf.Free search · Quote in 2–5 business days
Motorcycle Parts Website
Home › Custom fabrication

Custom & One-Off Parts

When the part does not exist, we have it made: measured from your original, drawn, machined, cast or formed by specialists who do this for a living.

When custom is the answer

Three situations: the part was never common and no stock survives; the part exists but at a price that makes a made-to-order copy sensible; or you want something that never existed (a different ratio, a stronger alloy, a bracket for a modern component on an old frame). In all three we start the same way, by understanding the original.

The process

Measure and document

Send the broken or worn original. We measure, photograph and, where it helps, 3D-scan it. Reverse engineering a part from a damaged example is routine; from a photo alone is harder but sometimes possible with factory drawings.

Draw and confirm

You get a drawing or model to approve, with material and finish called out. For fit-critical parts we may make a test piece first.

Make

CNC machining for most metal parts; casting for cases, covers and brackets; metal spinning for lamp shells and covers; hand-forming for tanks and fenders. Plating or paint to match.

Verify and ship

Checked against the drawing and, where we have the original, test-fitted. Crated per the shipping page.

What we have had made

  • Brass and steel headlamp shells spun to original profiles
  • Kickstart and gear-change shafts in modern alloy
  • Small-batch cast primary covers for pre-war singles
  • Carburetor float bowls and tops for obsolete instruments (see carburetors)
  • Tank badges and emblems, cast and enameled

Honesty about custom parts

A made-to-order part is a reproduction and is labeled as one, even when it is better than the original. For how that affects value and judging, read NOS vs. reproduction. For antique bikes in particular, see the antique parts page.

Timelines and pricing

Four to twelve weeks is typical. Quoted as a project: measurement, tooling if any, the part, finish and shipping. One-off parts cost more per piece than a small batch, so if a club or forum wants five, say so.

MPW
Written by the Motorcycle Parts Website sourcing deskOur brokers have spent years in swap meets, estate buys, dealer back rooms and club registries. Every guide is reviewed against the parts we have actually handled; where we have not handled something, we say so.

Tell us what you are hunting.

Model, year, part number if you have it, and a photo of the old part if you do not. Searching is free; you only pay when we find it and you say yes.

Request a part